The metal roofing division of Wise Builders Roofing and Renovations

Metal Roof Re-Screw and Repairs in Gulf Shores, AL

The panels on this coastal home were still good. The screws weren’t. A re-screw and targeted repairs added years to the roof for a fraction of the cost of replacing it.

Project at a Glance

What We Found

Exposed-fastener roofs hold up for decades, but the screws and their rubber washers don’t. Salt air and sun break down the washers, the screws rust and back out, and water finds the holes. On this roof we found rusted, backed-out screws at the hips and valleys and a rusted penetration someone had tried to seal with caulk.

Rusted, backed-out screws at a hip and valley on a metal roof in Gulf Shores, AL
Rusted, backed-out screws
Rusted roof penetration patched with caulk on a metal roof in Gulf Shores, AL
Rusted penetration patched with caulk

What We Did

We re-screwed the roof with new fasteners, made the roofing repairs, and removed the old chimney chase and swapped in new panels. On the lower roof we stripped a section to the underlayment and laid new panels and flashing.

Two days, and the roof is sealed again.

New metal panels and flashing going on a lower roof in Gulf Shores, AL
New panels and flashing on the lower roof
Even rows of new fasteners across a re-screwed metal roof in Gulf Shores, AL
New fasteners across the panel field

Before and After

Brown exposed-fastener metal roof with a rusted vent before a re-screw in Gulf Shores, AL
Before
Full metal roof plane re-screwed with new fasteners in Gulf Shores, AL
After: re-screwed
Dormer and finished metal roof after a re-screw and repairs in Gulf Shores, AL
After: dormer and roof

Is Your Metal Roof Leaking at the Screws?

If the panels are sound, a re-screw usually beats a new roof. We’ll check it and tell you which one you need.